[et_pb_section fb_built=”1″ theme_builder_area=”post_content” _builder_version=”4.17.3″ _module_preset=”default”][et_pb_row _builder_version=”4.17.3″ _module_preset=”default” theme_builder_area=”post_content”][et_pb_column _builder_version=”4.17.3″ _module_preset=”default” type=”4_4″ theme_builder_area=”post_content”][et_pb_text _builder_version=”4.17.3″ _module_preset=”default” theme_builder_area=”post_content” hover_enabled=”0″ sticky_enabled=”0″]
Summary
Inspection Detail
Attic, Insulation and Ventilation
Roof – Condo/Townhome
Attached Garage
Interior, Doors, Windows
Exterior – Condo/Townhome
Kitchen
Laundry
Bathroom
Plumbing
Electrical
Water Heating Equipment
Heating
Cooling
Mold Inspection
Premier Partners
You’re currently not viewing the full report.
VIEW FULL REPORT
3518 W 63rd Ave
Denver, CO 80221
Summary Text (enter here)
The attic access hatch was not properly insulated. A qualified contractor should evaluate and repair or replace as necessary.
EDIT
Baseboard trim was missing in areas of the interior walls at the time of inspection. A qualified contractor should evaluate and repair or replace as needed.
The drywall wall, ceiling, and/or trim was not finished properly. This may be one or more of the following: loose sections, missing pieces, missing caulking and/or paint, or poor application of any of the wall, ceiling, finishing components. A qualified contractor should evaluate and repair or replace as necessary.
The floor covering was not sealed at the edges and may allow moisture intrusion. A qualified contractor should evaluate and repair or replace as necessary.
Floor covering materials were missing at interior areas. Recommend a qualified contractor evaluate and install as necessary.
The door had missing or damaged floor guides. A qualified contractor should evaluate and repair or replace as necessary.
Electrical outlets had missing faceplates. A qualified contractor should evaluate and repair or replace as necessary.
At the interior stairs, the handrail was missing. A fall or injury could occur if not corrected. A qualified contractor should evaluate and repair or replace as necessary.
A supply register was missing the cover. A qualified contractor should evaluate and repair or replace as necessary.
There was peeling paint and/or deterioration at the entry door. Recommend a qualified contractor for further evaluation, repair and/or replace.
The floor covering was not sealed at the edges and may allow moisture intrusion. A qualified contractor should evaluate and repair or replace as necessary.
Although outside the scope of a general home inspection, the inspector noted the refrigerator ice and/or water dispenser was not working. A qualified contractor should evaluate and repair or replace as necessary.
The drywall wall, ceiling, and/or trim was not finished properly. This may be one or more of the following: loose sections, missing pieces, missing caulking and/or paint, or poor application of any of the wall, ceiling, finishing components. A qualified contractor should evaluate and repair or replace as necessary.
The window could not be opened at the time of inspection at main floor restroom. A qualified contractor should evaluate and repair or replace as necessary.
The bathtub spout was missing. A qualified contractor should evaluate and repair or replace as necessary.
The water temperature was below the suggested range of 120-130 degrees. Recommend adjusting the water heater thermostat first. If water does not reach the acceptable range then a qualified contractor should evaluate and repair or replace as necessary.
The secondary drain line was capped or not routed to a drain. If the primary drain line becomes blocked, this condition could cause condensation to not drain properly and possibly damage the unit. The inspector recommends installing a secondary drain or installing an over flow protection device. A qualified contractor should evaluate then repair or replace as advised.
The blower motor, wheel, and/or cabinet appeared to be dirty at the time of inspection. Blower fans/wheels are subjected to constant dirt, dust, and lint and can become overly dirty when not cleaned on a regular basis and even faster if the air filters are not changed regularly.
A qualified contractor should evaluate, clean, and service as necessary, and certify the unit is in good working order.
[/et_pb_text][/et_pb_column][/et_pb_row][/et_pb_section]
