Inspection Detail
Roof – Condo/Townhome
Exterior – Condo/Townhome
Attic – Not Present
Garage Not Present
Interior, Doors, Windows
Kitchen
Laundry
Bathroom
Plumbing
Central Water Heating
Electrical
Heating – Baseboard
Cooling – Window/Wall AC
Mold Inspection
Premier Partners
The wall showed wet staining indicating moisture intrusion did or does still exist. A qualified contractor should evaluate and repair or replace as necessary.
The floor had a noticeable hump or rise. A qualified contractor should evaluate and repair or replace as necessary.
The door had a damaged or missing doorstop. A qualified contractor should evaluate and repair or replace as necessary.
The door had areas of peeling paint. A qualified contractor should evaluate and repair or replace as necessary.
The sealant was damaged and deteriorated around the window. Recommend a qualified contractor to repair or replace as necessary.
The light fixture was damaged. A qualified contractor should evaluate and repair or replace as necessary.
The floor had a noticeable hump or rise. A qualified contractor should evaluate and repair or replace as necessary.
The dishwasher drain line was dirty and/or possibly clogged at the time of inspection. This may be related to the lack of a “high loop” in the drain line. A high loop in the drain hose is to keep water from settling in the hose to prevent any odors from backing up into the dishwasher. A smell or mold may appear if not corrected. Recommend a qualified contractor to evaluate and repair or replace as needed.
The laundry room did not have an exhaust fan or an openable window. A qualified contractor should evaluate, then repair or replace as advised.
An outlet did not provide Ground Fault Circuit Interrupter (GFCI) protection. Although GFCI protection of circuits may not have been required at the time in which this home was built, safe building practices have improved with the passage of time and building standards have changed to reflect current understanding. The inspector recommends updating the existing electrical circuits to include GFCI protection. A qualified contractor should evaluate and repair or replace as necessary.
The water temperature was higher than the acceptable range of 120-130 degrees. Recommend adjusting the water heater thermostat.
Solid copper wire over stripped. Recommend a qualified contractor for reevaluation or repair as necessary.
Baseboard heater damage On the top cover. Recommend a qualified contractor for reevaluation and repair as necessary.
